|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Fitting 05-06 clarke tanks on '07 FSR450
Has anyone done it? would like to get some tips how it is possible, it seems that under the seat comes a gap into the airbox.. I am trying to make this happen to save money
|
#2
|
||||
|
||||
It will work. i did it until 07 tanks were available. Upper shroud screws didnt line up and seat was tight but it worked.
__________________
Dont follow me, You wont make it. |
#3
|
||||
|
||||
ok, so it is a question about "making" it fit (with a little violence ) rather than modifying the seat or anything?
|
#4
|
||||
|
||||
Yep, just have to get a little violent.
__________________
Dont follow me, You wont make it. |
#5
|
||||
|
||||
hehe, will do. Thanx alot!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help! fitting FSE400 engine in kart, do you hav one? | Gi_GASGAS | Enduro Electrical & Wiring | 1 | 05-13-2010 12:52 AM |
fitting Clarke 3.2 tank to a '03 ec250 | flybars | Enduro Chassis & Body | 2 | 04-11-2010 04:57 PM |
fitting KTM rear wheel to Gasser | moto520 | Enduro Chassis & Body | 3 | 03-19-2007 07:42 PM |