|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-10-2020, 06:31 AM
|
|||
|
|||
Kick starter
Hey Gang, so while I'm waiting on my flywheel puller and stator to get here I decided to fix my kickstarter. Open up the lever and it takes about 4 or 5 inches for the lever to engage the gears. Almost half the stroke. Anyway, took it all down yesterday and really didn't see anything that was out of whack. Ratchet still works, sometimes the spring gets stuck at the bottom also. Any ideas?
TIA
__________________
Dick Carnes "If ya run, you'll only die tired" 2019 EC 300 2018 GP 300 2013 XC 300 (sold) 2006 DE 300 (buddy has it) 
|
|
#2
03-10-2020, 06:41 AM
|
||||
|
||||
|
The engagement dogs are probably not timed right.
Check out the instructions in the shop manual. https://www.dropbox.com/s/i93vw77r9k...anual.pdf?dl=0
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kick starter | Jakobi | Enduro Engine - 2 stroke | 11 | 02-16-2013 07:36 AM |
| kick starter help | jhendr3702 | Enduro Engine - 2 stroke | 13 | 12-09-2011 11:13 PM |
| Kick Starter ? | rockrider1 | General Discussions & Announcements | 1 | 11-04-2010 08:49 AM |
| 07 250 Kick Starter | prk03 | Enduro Engine - 2 stroke | 2 | 03-28-2009 10:59 PM |
Linear Mode
