|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CDI switch on an EC200
Hi
Basically i've got an '07 ec200 without the switch on the bars, is it worth replacing? (as in does it make much difference) 'cos the winter mud is approaching
__________________
'07 GasGas EC200 '03 GasGas 400FSE (sold) |
#2
|
||||
|
||||
You should be able to switch it by connectin/disconnecting 2 short wires which come out of the cdi an when connected form a loop.
Connected is sun mode, and disconnected is rain, I think. I notice a subtle difference between the 2 modes on my 07' 200, rain is slower to rev up and doesnt snap as fast, sun is faster revving and snappier... |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
missing CDI switch | captainslow | Enduro Electrical & Wiring | 0 | 05-20-2010 08:38 AM |
Dual Map switch.. | stevehipkiss | Enduro Electrical & Wiring | 3 | 01-28-2010 01:29 PM |
Seriously contemplating switch. | REVERUP | General Discussions & Announcements | 11 | 11-14-2009 06:35 PM |
headlight switch | jasont1532 | Enduro Electrical & Wiring | 1 | 03-02-2009 07:20 PM |
Kill Switch | Dingo | Enduro Electrical & Wiring | 4 | 12-10-2008 04:23 PM |