|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
float bowl hight
What is the correct float bowl hight for my 2000 300EC ?
thanks. |
#2
|
||||
|
||||
Float level spec is 16mm, with the carb at an angle so the spring in the needle is not compressed. This works out to be where the seam in the float is parallel to the bottom of the carb body. If you have issues with overflow you can go a mm or so lower (17-18mm). Check that the floats are straight and not twisted.
|
#3
|
|||
|
|||
thanks & yes i do have overflow problem, also its hard to start from cold, once its been started its fine been told to check the bowl hight before i do anything else so i'll check that after
thank you. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Float Bowl Gasket - Alternative | Harry | Enduro Intake/Carburetion - 2 stroke | 4 | 02-08-2012 01:26 AM |
Carb issues - Float bowl? | Hicksi | Enduro Intake/Carburetion - 2 stroke | 7 | 10-19-2011 11:21 AM |
float bowl height on 2010 300??? | nambo-trev | Enduro Intake/Carburetion - 2 stroke | 4 | 06-19-2011 01:08 PM |
Lodi Cycle Bowl Marathons | Rick | Western United States | 0 | 12-13-2009 06:13 PM |
Float Bowl HELP! | gasIdaho | Enduro Engine - 2 stroke | 3 | 07-18-2007 09:30 PM |