|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Placement of Throttle Cable
Has anyone else had a problem with burning the throttle cable? I noticed when I purchased my fse400 that the cable was burnt and it got worse after taking it out on the first ride. It was running horizontally out from the throttle body and then between the radiator and the frame. This made it run very close to the pipe where it was coming out of the head. I am getting a new cable and don't want to make the same mistake. It could cause serious problems and strand me out in the bush.
Thanks.
__________________
John B. '03 GasGas FSE 400 '97 Honda CR 250 '02 Honda VFR800 |
#2
|
||||
|
||||
It shouldnt be routed that low.
__________________
Dont follow me, You wont make it. |
#3
|
|||
|
|||
I can't tell you how glad I am to hear of a problem my '05 FSE doesn't have! Mine won't melt the throttle cable, to do that it would have to start (kick or electric) and then stay running (just "shuts off" now and then). Haven't dared take it more than 1/2 mile from home (couldn't push it back from any further), now it's warm enough that I don't want to push it at all so it will probably continue to gather dust until fall. I sure wish there was a dealer within a few hours ride who knew anything about them.
Bruce
__________________
No one ever calls the Fire Department because they did something smart |
#4
|
||||
|
||||
Quote:
|
#5
|
|||
|
|||
found out that it had the wrong cable on it. It was replaced by the dealer and I hope to get out and test it soon if the freaking rain here in TX would stop for a day or two...
__________________
John B. '03 GasGas FSE 400 '97 Honda CR 250 '02 Honda VFR800 |
#6
|
|||
|
|||
Quote:
Bruce
__________________
No one ever calls the Fire Department because they did something smart |
#7
|
||||
|
||||
Fire escape,most likely the relay is bad. I cant recall the NAPA # we use but will find it or you could search on here as its been talked about before.
__________________
Dont follow me, You wont make it. |
#8
|
|||
|
|||
Quote:
Thanks, search came up w/ NAPA #AR 614, I'll try and find some! Bruce
__________________
No one ever calls the Fire Department because they did something smart |
#9
|
||||
|
||||
Make sure the wiring harness under the lowest part of the tank is seated properly. If it's not "snapped" into place it can vibrate loose, causing your bike to run erratically.
__________________
'05 EC450FSE '02 MC250 |
#10
|
|||
|
|||
Thank You, Thank You, Thank You!
I picked up the NAPA relays this morning, expected to have to modify some wiring but they are a PERFECT fit and the bike fired right up AND kept running. Even got out for a short ride and got partly burried, only up to the swing arm, on a friends farm road. Had to lay the bike pretty much on it's side to work it out of the sand, silt, clay (leftover from a flood this past spring), would have been kicking over my Kawi for a while after that, the FI didn't flood, started right back up! The only down side is that last week I was ready to trade it for an "adventure" bike, now I'll have to find room to add the new bike. Thanks again!
Bruce
__________________
No one ever calls the Fire Department because they did something smart |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Throttle cable / slide | Gassey fan | Enduro Intake/Carburetion - 2 stroke | 4 | 03-04-2009 11:23 AM |
Throttle Cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-14-2009 02:39 PM |
throttle cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-08-2009 06:17 AM |
Throttle cable | dave948 | Enduro Intake/Carburetion - 2 stroke | 7 | 10-10-2008 04:16 PM |
Throttle Cable Crossover | Ed Ventura | General Discussions & Announcements | 8 | 08-29-2008 05:55 AM |