|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Most wanted parts
OK, this is all about your most wanted parts. If it's made, maybe someone has an extra laying around. If it's not made, maybe we can have it made. I recently sent out the stock base valves from my Ohlins forks. They were destined to spend an eternity in my garage, but they were needed by a fellow GG rider.
The list: 1. lower triple clamp for Ohlins forks - stock is too expensive.
__________________
Mike Baxter 2005 GasGas EC300 (Ohlins front and rear) 2007 Yamaha FZ1 2003 Pampera 280(hers) |
#2
|
||||
|
||||
The little plastic bits that stop water getting in the extra hole in the rear rim, though maybe my dealer can get them?
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#3
|
||||
|
||||
Check with all the brands dealers for that little plug.
__________________
Mike Baxter 2005 GasGas EC300 (Ohlins front and rear) 2007 Yamaha FZ1 2003 Pampera 280(hers) |
#4
|
|||
|
|||
Mike, Thanks Again for the base valves. I will use then soon. Just a thought about the clamps, would a Yamaha clamp work? I know they made some 46mm forks simliar to the Ohlins.
Paul |
|
|