|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cleaning fork tubes
On other bikes, the plastic covers for the fork tubes are open on the back side. Lots of room to slide a rag in and clean the tubes. On the GG the back side is mostly closed. I don't see the access improving much even with the latches pushed open. How do you get at the fork tubes?
In the past I've put WD40 on a clean rag and pulled it around to clean off the hard water spots or slight dirt left behind after washing. I'd rather not undo the three mounting screws per side plus the cable clamp just to get the covers off (each time I clean the bike).
__________________
2011 EC250E |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
coating rubbing off fork tubes | swazi_matt | Enduro Suspension | 16 | 04-26-2012 12:53 AM |
tubes | kiss161 | General Discussions & Announcements | 8 | 02-27-2012 08:53 PM |
Tubes | geraldh | General Discussions & Announcements | 19 | 02-15-2010 03:56 PM |
BIB Vs. Tubes | Boomhauer | Enduro Chassis & Body | 1 | 01-15-2007 05:16 PM |