|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
2019 EC 300 Air filter Fitting
Changing out the air fiter for the first time
Got a new funnel web and oiled it up. Fitted it up and at first it sealed ok at the left side but not on the upper side. A bit of wiggling and it seemed to fit better on the top with the black seal surface surface making good contact with the air box. When I fiited the spring loaded rod it fitted into the platic cup at the back of the airbox but it seems to be at a strange angle. Hopefully you can see this from the photos. Have i messed up? Is there some tips/ tricks to replacing the filter? Or does it look ok? [ATTACH][ATTACH][ATTACH][ATTACH]20201110_170612.jpg[/ATTACH][/ATTACH][/ATTACH][/ATTACH]
__________________
2019 EC 300 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fitting a keyignition to a EC 125 05 | Wilmer | Enduro Electrical & Wiring | 0 | 01-09-2018 03:27 AM |
2000 air filter vs. 2011 filter? | nknudsen | Enduro Intake/Carburetion - 2 stroke | 2 | 05-22-2014 12:00 PM |
AIR FILTER BOX RUBBER and CARB Fitting (ec200 2011 sixd) | eliasn101 | Enduro Engine - 2 stroke | 13 | 07-12-2013 10:48 AM |
Nambotin fitting in well at KTM | Keg | General Discussions & Announcements | 9 | 01-14-2012 10:07 AM |
Fitting map switch to 200? | blanc | General Discussions & Announcements | 7 | 12-14-2010 07:44 AM |