|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
can,t get idle up
2005 ec 200 - idle screw is turned in all the way can,t get idle up any more air screw is adjusted. bike runs great could it need a one size smaller pilot jet ? just need to get a few more RPM at idle.
thanks geno |
#2
|
||||
|
||||
What needle do you have in it now?
If you go one size leaner on the pilot - it will just worsen the situation you are in. Going with a leaner needle and a richer pilot will help. Right now - you are "pulling over" - which is having the idle screw cranked in to supply more fuel/air via the nozzle/needle - this is because the pilot is lean, etc. But it's a circular problem - needle too rich/pilot too lean then crank up idle to try to balance air/fuel ratio.... The ultimate fix is to send your carb to RB-Designs - he fixes the carb internally to resolve the sensitivity issue that it has on the idle/pilot circuits, bores it out and installs a divider plate, etc. jeff |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gas gas won't idle? read this! | ricardo cabeza | Enduro Intake/Carburetion - 2 stroke | 19 | 10-07-2013 01:33 PM |
fasr idle | woody1965 | Enduro Engine - 2 stroke | 1 | 02-26-2010 12:46 PM |
EC 250 05 noo idle. settings?? | Laban1234 | Enduro Intake/Carburetion - 2 stroke | 5 | 07-21-2009 11:13 AM |
OK, how do I adjust the idle | thelonius | General Discussions & Announcements | 2 | 04-25-2009 07:41 PM |
Low Oil light at idle | floored | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 10-02-2008 09:49 AM |