|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2018 ec 300 power valve issue
Hey guys,
Over the weekend I decide I wanted to see what setting my power valve was at so I found this video and followed its instructions https://youtu.be/lu3T-ctnzKY I did have one problem, after loosening the lock nut I found that the lock nut was seized to the alan key so I did something silly and removed the lock nut with the pin inside so I could free up the lock nut. Well after freeing up the locknut I re installed it back into the bike, i set the pin at 2 turns out then tightened the lock nut. When nipping up the locknut it started to turn something inside the motor so I stopped what I was doing and called my local gas gas dealer. They are saying I need to bring them the bike so they can reset the power valve, is this an easy job that I would be able to do myself? I'm pretty annoyed at myself for stuffing this up so just wanted other people to know so they dont make the same mistake I did. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 XC 300 Power Valve adjustment | Islander | Enduro Engine - 2 stroke | 3 | 07-11-2018 09:44 AM |
Ec300 rattle/power valve issue | Smithwoodwest | Enduro Engine - 2 stroke | 6 | 12-22-2016 07:46 PM |
Headlight power issue | adriano.ro | Enduro Electrical & Wiring | 6 | 02-08-2016 12:57 PM |
ec125 -01 power valve issue? | Nicolas89 | Enduro Engine - 2 stroke | 83 | 08-06-2014 04:33 AM |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |