|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Quote:
thanks
__________________
broken down over 60 slow rider.. |
#12
|
||||
|
||||
I haven't watched your video but I have to agree with Bailey on this aswell. The thick needle diameter is what causes everyone to turn the idle screw in a long way to get a sustainable idle. Its what causes the burbling at light throttle openings, and what this is is essentially fuel passing through unburnt.
N1EF my bike ran strong but spooged alot. It would load up the plug a bit if lugged, and clear out when hammered. I'd get 70km to a tank. NEDW is leaner off the bottom and into the mid. Throttle response is better. Only a light burble right off idle. Its easier to ride fast as you don't have the rich to lean transition on the bottom end. And I get 100km to a tank. |
#13
|
||||
|
||||
awesome.. thanks everyone..
__________________
broken down over 60 slow rider.. |
#14
|
||||
|
||||
Hope you have sucess! Watched your vid. Wasn't boring at all. Not sure which bike was yours but the one with the helmet cam sounded good! Looked like some nice trails too. Those open fields.. We don't see that kind of stuff where I live.
|
#15
|
||||
|
||||
Quote:
.that is one of the few other gg's here.. it is an 02 300 and it runs great.. he has no idea what is in the carb... go figure.. but he says it wont idle at all... he is a very good rider.. this particular day, there were more gg's than anything else..(2) have needles ordered.. have packing..i will get it.. thanks again jay
__________________
broken down over 60 slow rider.. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wiring for dummies | tyman | Enduro Electrical & Wiring | 2 | 12-14-2008 06:26 PM |
jetting help for 05 300 please... | mackmack | Enduro Intake/Carburetion - 2 stroke | 5 | 09-03-2007 05:10 PM |
06 300 jetting | fury1 | Enduro Intake/Carburetion - 2 stroke | 1 | 07-31-2007 06:37 AM |
02 ec 250 jetting help | crem55 | Enduro Intake/Carburetion - 2 stroke | 9 | 07-12-2007 01:44 PM |