|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Head orings
Either the search here sucks or I do.
What was the trick to keeping the orings in the grooves until you get the head on ? Got it. I stretched them a bit. Last edited by Brian VT; 09-04-2008 at 10:00 PM. |
#2
|
|||
|
|||
Another trick I use is to coat the o-rings with some vaseline.
|
#3
|
||||
|
||||
I did just as you did. I gently stretched them a few times and they stayed in their seats with no problems.
__________________
2004 GasGas DE250 |
#4
|
||||
|
||||
And if you stretch them a little too much, just throw into the freezer for a bit and they will shrink back
|
#5
|
||||
|
||||
Josh, go ahead, tell them about shrinkage.
__________________
2004 GasGas DE250 |
#6
|
||||
|
||||
Well it's what happens when the water is just a little too cold for the
frank and beans |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
head differences 03-05 450? | Motarded1 | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 05-03-2008 07:43 PM |