|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
question on LH crank seal
Hi guys,
MY bike is running really bad, wont rev past half revs etc, I know could be a number of things but im just going to start and work my way through things, I know it can be Cranks seals so have ordered them and going to start there. My question is do you use any gasket sealant on them like yamabond etc? on the web ive seen some people do and others put them in dry but couldn't find anyone thoughts of a gas gas owner? many thanks si |
#2
|
|||
|
|||
I was looking up the exact same thing last week, in the end I decided to use a thin smear round the outer to help it seal and some grease on the inner lip
I pretty much pushed it into where it needs to be with my fingers, left it an hour and when I re did a leak test it was all good |
#3
|
|||
|
|||
Quote:
|
#4
|
|||
|
|||
It's been causing me some serious problems finding the fault with mine
I would recommend buying or making a leak down tester for peace of mind |
#5
|
|||
|
|||
Most common fault seems to be stator coil. Those plastic covers are crap!
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#6
|
|||
|
|||
Thanks. Ive read that as well. The case seal seems a much cheaper option so im going to start there!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Right side crank seal question | noobi | Enduro Engine - 2 stroke | 5 | 07-16-2010 07:49 PM |
Crank seal gone on rebuild? | stay_upright | Enduro Engine - 2 stroke | 11 | 09-13-2009 03:49 AM |
Crank Seal | kim | Enduro Engine - 2 stroke | 2 | 05-18-2008 09:41 PM |
crank seal size | rupecopp | Enduro Engine - 2 stroke | 3 | 04-18-2008 09:11 PM |
Crank seal leaky. | gasgasman | Enduro Engine - 2 stroke | 6 | 10-05-2006 07:46 PM |