flywheel wieght..

[jhendr3702]

on the 07 mc250... can i add a fww to it ?

[cbutler]

I put one on my 03 MC250

12 or 14oz I believe easy install to takes like two minuets.

[gasgasman]

Yes you can.
If you are trying to tame it down, you can always put a fywheel and stator with the lighting coil on it.

The MC has a very small flywheel.

G2 throttle works well also. I know where you can get one cheap. Hint hint...
I tried it but had too much "delay" for me.

[jhendr3702]

i really like a fww.. you can tell the mc has a small fw..
we were riding a trial today called jalapeno...there is a pretty good rocky hill at the end of it.. the mc pulled the front wheel at the bottom and was almost at a ground loop at the top..
fun stuff..

[jhendr3702]

can i swap the fw off my 01 300 to see how that does ?

it is a 2k2

[GMP]

The 2K-2 and 2K-1 (whats likely on the MC) flywheels are the same size. The 2K-1 stator has no lighting coil. You can use any weight for a 2K-2 flywheel, like the spin on weights from GoFasters.

[jhendr3702]

Originally Posted by GMP

The 2K-2 and 2K-1 (whats likely on the MC) flywheels are the same size. The 2K-1 stator has no lighting coil. You can use any weight for a 2K-2 flywheel, like the spin on weights from GoFasters.

gotcha..thanks

[jhendr3702]

orderd a steahly this am.. will report back

thanks guys

G.. let me see how this works and I will let you know on the g2..

jay

[lankydoug]

My 03 EC200DE had the light ignition so I put a weight that replaced the crankshaft nut (12oz I think) and it is now perfect. It smoothed it out without turning it into a slow revving tractor.

[jhendr3702]

Originally Posted by lankydoug

My 03 EC200DE had the light ignition so I put a weight that replaced the crankshaft nut (12oz I think) and it is now perfect. It smoothed it out without turning it into a slow revving tractor.

that is exactly what i am looking for..