|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Tire size question
Would a slighty used Michelin 140 fit on a 200 a lot off trouble? I don't as a rule even remount rear tires but times ure tough. Will it work, tire too big, any suggestions helpful.
Thanks, Jim |
#2
|
||||
|
||||
biggest i have had is michelin 130/80 mounted in the past.. i do not know if bigger will rub silencer on bottom out...i think michelin 140/80 is same as metric 120/100 (or 90?)
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#3
|
||||
|
||||
yea...the 140 will work on a 200, ran S-12's for a while. Nice!
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rear tire size choices.. | stainlesscycle | Enduro Chassis & Body | 5 | 03-22-2010 03:54 PM |
Nut Size | steve | Enduro Engine - 2 stroke | 2 | 01-11-2008 10:58 AM |
Tire stand for moose or tire balls | kim | Enduro Other... | 6 | 12-28-2007 12:12 AM |
Another Tire Question? | Boomhauer | General Discussions & Announcements | 0 | 08-26-2007 04:57 AM |
Stock tire size | joey11 | Enduro Chassis & Body | 0 | 06-14-2007 07:04 AM |