|
|
|||||||
| Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
|
Thread Tools | Display Modes |
|
#1
02-15-2010, 02:20 PM
|
||||
|
||||
no spark...
bike was fine, now i get no spark.
i'm thinking it's the stator. i hope it's not the cdi.. but my coil gives me a wonky reading..here's what i have: coil primary windings (blu/w to g) - .7 ohm (i would assume i should get 2.5ohm- 5 ohm right?????) secondary windings (no plug wire) 12.7 kohm stator: pulser coil 93ohm, jumps to 115ohm when magnet passes (this i assume is good.) exciter coil - 0ohms and under 2volts when kicked 5 times. (this is not good i assume..) any ideas???? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another no spark question... | egesledder | Enduro Electrical & Wiring | 1 | 08-20-2010 06:27 AM |
| Fix for no spark | brains | Enduro Electrical & Wiring | 2 | 08-14-2010 12:38 AM |
| EC 250 Spark plug | Grampy | Enduro Engine - 2 stroke | 11 | 12-16-2008 12:24 AM |
| weak spark | tallboy350 | Enduro Electrical & Wiring | 5 | 11-24-2008 08:18 PM |
| End cap with spark arrestor | Qui-gon | General Discussions & Announcements | 3 | 05-08-2008 04:41 PM |
Threaded Mode