tranny

steve · #1 03-25-2008, 01:27 PM

In the course of moving my motor around othe bench the shift-shaft spring and the all 3 shift forks and shafts fell out of the motor completly!Any help or suggestions on the correct way to install them correctly.Please help my wife busting my balls about not doing it right,I can't let her say''I told you so'' !

PEB · #2 03-26-2008, 11:19 AM

Steve, I assume you have the bench manual for the newer bikes. If not download it, The whole teardown is covered in depth. If I recall corectly the shift forks and drum will only fit in one way.

Loosenut · #3 03-26-2008, 12:56 PM

They will fit more than one way, but it won't shift. However, it's pretty easy to figure out with the manual.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
02 300 tranny	jhendr3702	Enduro Engine - 2 stroke	4	09-30-2010 05:11 AM
New tranny technology	lankydoug	Enduro Engine - 2 stroke	4	09-23-2010 05:34 AM
milky tranny fluid	skid jackson	Enduro Engine - 2 stroke	62	06-12-2010 06:54 PM
Tranny Filler Plug	Rick	Enduro Engine - 2 stroke	20	03-08-2010 04:08 PM
Tranny oil for 00 GG 250 MC?	scarylarry	Enduro Engine - 2 stroke	7	08-05-2008 07:11 PM