|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#21
|
||||
|
||||
Skid, the .5mm is fine.
__________________
2004 GasGas DE250 |
#22
|
|||
|
|||
If you set your squish band close or are very particular about port timing then you need to check your installed dimensions every time you replace the piston. When I put a new piston in my '06 EC300 the top of the new Vertex piston at the outer edge was 0.23 mm higher than the top of the original piston at the outer edge. I set the base gaskets to compensate.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Changing the base gasket... | JoeH | Enduro Engine - 2 stroke | 3 | 08-28-2009 07:16 AM |
!!! Help with Base gasket thickness !!! | timlh | Enduro Engine - 2 stroke | 1 | 05-14-2009 07:58 PM |
thinner base gasket | fullthrottle | Enduro Intake/Carburetion - 2 stroke | 4 | 06-01-2008 08:09 AM |
Base gasket preparation? | d2w | Enduro Engine - 2 stroke | 7 | 06-25-2007 06:30 AM |
Base Gasket | gtsnowcrack | Enduro Engine - 2 stroke | 6 | 09-09-2006 05:43 AM |