|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
11-24-2017, 01:59 PM
|
||||
|
||||
How do I remove the ignition sprocket?
Help! I’m repairing the e-start on my ‘13 XC300 and can’t figure out how to remove the ignition sprocket. I see threads inside the large nut holding the sprocket on. Do I need a special tool that threads in there, or does anyone have any other tricks to keep the unit still so I can remove the large nut on the sprocket?
I figured the Honda bendix swap would be the more difficult part... Thanks! Last edited by BLD; 11-24-2017 at 03:03 PM. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ignition sprocket | pigpen966 | "Wanted to Buy" & "Want To Trade" | 4 | 10-25-2017 05:09 PM |
| Flywheel Ignition sprocket wanted | nestz | Parts | 6 | 11-19-2016 11:36 AM |
| How to remove Flywheel? | Fabry | Enduro Engine - 2 stroke | 12 | 08-16-2013 03:27 PM |
| how do you remove the kickstart | noobi | Enduro Chassis & Body | 13 | 09-22-2011 03:31 PM |
| 04 300EC Ignition changed to DE Ignition | Trail Blazer | Enduro Engine - 2 stroke | 0 | 01-08-2007 01:48 AM |
Threaded Mode