|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
01-19-2021, 02:24 PM
|
|||
|
|||
Can't select neutral/Shift cam question.
Hi all,
Iv done a bottom end rebuild on myEc250 and can't find neutral... Going through all gears fine but no natural. What I want to know is there a right way the shift cam has to be reinstalled? I read that I need to turn it 180???? Can you adjust the shift cam without splitting the engine? 😭 Thanks in advance. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can't put on neutral gear | Getoviq95 | Enduro Engine - 2 stroke | 13 | 01-19-2021 01:03 PM |
| 18 XC 300 neutral cable | Wypipo | Enduro Electrical & Wiring | 0 | 10-04-2018 12:35 PM |
| Help me select the right Mid West Engineering lever | Bark3rd | Enduro Chassis & Body | 13 | 05-12-2016 10:57 AM |
| Off idle bog in gear not in neutral | bluespark | Enduro Intake/Carburetion - 2 stroke | 14 | 04-30-2016 06:01 PM |
| Gear shift shaft question (again) | Trailrider | Enduro Engine - 2 stroke | 7 | 04-06-2010 09:54 AM |
Threaded Mode