|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
FSE Clutch Question
Does the FSE share a clutch with any other bike?
Dragging clutch, worst than usual. Long story short. I take the side cover off the clutch, after checking the hydraulic system. As I took the clutch disks out, the deeper I got into the basket the less fiber material was on the fiber plates. The first 3 fibers I took out looked pretty new, plenty of material, next to the last fiber plate had 2 pads missing, and very thin. Is this normal for a motorcycle clutch? Thanks.
__________________
04EC300 04Wild450 07FSR450 |
#2
|
||||
|
||||
I don't know anything for sure, but the obvious place to look regarding the FSE would be the S*zki DRZ400. They share a lot of parts.
|
#3
|
||||
|
||||
If it has a slipper clutch then only the fibers are the same as 2st GG. If no slipper then all is the same. Fiber plates for Honda CRF 450 will work but there are a few manufacturers that have plates for GG specific. We use and have had no problems with Moose brand.
__________________
Dont follow me, You wont make it. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anyone fitted a carb? & starter clutch question | sgoaty | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 05-25-2011 05:02 AM |
Clutch question. | darren | Enduro Engine - 2 stroke | 5 | 09-23-2010 09:16 AM |
clutch basket question | mxdj2003 | Enduro Engine - 2 stroke | 3 | 02-02-2009 07:35 AM |
KTM 50 Clutch Question... | tprnottp | All Other Bikes... | 8 | 09-28-2008 11:17 PM |