Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Electrical & Wiring

Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 07-09-2018, 11:28 PM
mase mase is offline
Member
 
Join Date: Jul 2018
Posts: 2
Default stator lighting voltage

Hello all
I have just recently purchased a gasgas ec250 r 2012 ... All was fine in till a couple of days ago then my lights rear front, horn, brake light all packed in but bike runs fine.
I've tested voltage straight from stator and at lights and it's reading 4.2 volts tickover
but does increase when revved it will light a bulb up if I put it straight to yellow, white
Wire straight from stator plate but no were else
Just wondering any body else had this
Thank you


Reply With Quote


  #2  
Old 07-10-2018, 01:59 AM
SS109's Avatar
SS109 SS109 is online now
Senior Member
 
Join Date: Jan 2011
Location: Tucson, AZ
Posts: 987
Default

There are two separate circuits to the stator, the source coil which runs the bike and the lighting coil that, well, runs the lights! So, your problem is either the lighting coil failed, you have a bad switch, or a bad connection somewhere.
__________________
WildAzzRacing YouTube channel
Trail Riders of Southern AZ club
AZ State Parks OHV Ambassador
'11 EC250R
'98 KDX220
Reply With Quote
  #3  
Old 07-10-2018, 03:31 AM
mase mase is offline
Member
 
Join Date: Jul 2018
Posts: 2
Default

Ok thank you was suspecting lighting side as gone down. going to see if I can get it rewound today,
do you know what volts it should be kicking out as I said it's registering 4.2 no matter were I test it straight from stator light side.... or back/front light
Thanks
Reply With Quote
  #4  
Old 07-10-2018, 11:00 AM
Neil E. Neil E. is offline
Senior Member
 
Join Date: Mar 2007
Location: Gormley, Ontario, Canada
Posts: 1,418
Default

From the workshop manual, check these values for your stator. Test with the stator white and yellow disconnected.
Attached Images
File Type: jpg stator.jpg (89.5 KB, 21 views)
__________________
2011 EC250E
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Voltage regulator skippyjlo "Wanted to Buy" & "Want To Trade" 2 03-19-2017 08:36 PM
04 300 EC Voltage specs Packman Enduro Electrical & Wiring 2 01-17-2014 07:09 PM
to much voltage? whodat Enduro Electrical & Wiring 1 10-27-2011 04:25 PM
Voltage regulator sanderjavant Enduro Engine 4 stroke (including EFI & Exhaust) 3 09-22-2008 08:36 PM




All times are GMT -5. The time now is 03:46 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org