|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Steel Drive Plates
Hey!
I was in www.halls-cycles.com homepage. and looking after parts to my gasgas ec 250 -00 and I find STEEL DRIVE PLATES moose racing M807104. then i see it's same too Honda cr 250 90-01, is that right. can i use STEEL DRIVE PLATES from honda..... even if i buy them from another place.. I hope anyone can understand what i mean. my english i bad Thanks for answer Best regards nr1strange
__________________
gasgas ec250 -00 Last edited by nr1strange; 08-10-2008 at 04:51 PM. |
#2
|
||||
|
||||
We've found that the Moose and Barnett steel clutch plates work best in the older GasGas clutchs, 06 and older.
The newer clutch boss (inner clutch basket), 07 and newer, are made to slightly different specifications and the after market plates may not work. The Moose plates work in the newer basket but are a little tight. The Barnett steel plates absolutely do not work in the newer basket at all. If you purchase the after market plates don't wait till the last minute to see if they fit as they may not and you may be stuck without a clutch for your next ride if you don't leave enough time to reorder the OEM plates if you need them.
__________________
Steve Berkner I've attended 21 Six Days as a working Photojournalist |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
steel clutch plates | steve | Enduro Engine - 2 stroke | 3 | 03-15-2011 09:22 PM |
new clutch drive plates | dank | Enduro Engine - 2 stroke | 4 | 06-23-2010 11:15 AM |
GNCC Steel Creek | Rick | Off Road Racer's Corner | 1 | 03-22-2010 02:24 PM |
Final drive chain | anathema | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 04-14-2008 08:44 PM |