|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
12 ec300r false neutral 5th n 6th gear
Hi all
2012 ec300r Bike has done 47hrs, i sometimes get a false neutral between 5th and 6th only on a up change and tranny will slam into 6th after it get the nasty neutral rev out... Any one had this before? Any help much appreciated thanks rob |
#2
|
|||
|
|||
had it a couple of times on my 2013 - i just thought it was lazy shifting
|
#3
|
||||
|
||||
I would check the "scorpion" shown below(photo credit to stujohnson). Make sure there are no sharp edges on the shift fork that can cause a hang up.
You may also try a thinner transmission fluid. http://i1229.photobucket.com/albums/...ps3ecab0af.jpg |
#4
|
||||
|
||||
Quote:
gasgasman - Thank you for the advice. Next time I have my engine right cover off I will have to inspect that specific part.
__________________
2012 - XC 300 Racing Seattle, WA |
#5
|
||||
|
||||
Mine does it in some gears , mostly if I go to a motox track and very rarely if I'm riding enduro
|
#6
|
|||
|
|||
thanks for the info
I must admit i feel im the cause as im a soft shifter and the lever is just slightly too low for me but its not nice when it happens.. ill raise my lever and see how I get on then.. ill have a look inside on my next freshen up I think. |
#7
|
||||
|
||||
What fluid are you using and how many hours between changes?
As gasgasman said, check the scorpian |
#8
|
|||
|
|||
running motul expert.. bike is always serviced, mostlikely over serviced, oil after every weekend of riding usally
might be worth a look inside.. its bit of a concern.. hoping its not be selector fork issue |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pampera 250 false neutral between 5th and 6th | Schoe000 | Enduro Engine - 2 stroke | 0 | 10-21-2013 03:02 PM |
2012 ec300r | J. JuJu | General Discussions & Announcements | 5 | 08-08-2013 09:05 AM |
2013 EC300R lowering kit anyone? | skidmarx | Enduro Suspension | 12 | 03-16-2013 08:43 AM |
Setting up my EC300R 09 | Keg | General Discussions & Announcements | 4 | 09-27-2008 07:42 AM |