|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-09-2015, 04:10 AM
|
|||
|
|||
EC125 2013 top-end cross-over - certified information
I've been looking for top-end kit for my EC125 2013, and could not find any.
On Ebay I can find only for 2011 and below. Even on Athena's website (Athena makes the OEM pistons for the EC125s) I could not find it. I contacted them through the website, and their representative referred me to the following products - S4C05400016A piston P400485160003 gasket kit which are originally for YZ. So it is now safe to say that the top ends of the EC125 2013 and YZ are identical, at least when it comes to Athena's products. I'm writing this here for future reference, as I couldn't find an answer before. 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front brake lever cross for 2013 300 | shang | Enduro Chassis & Body | 4 | 11-24-2014 09:29 PM |
| 2013 lever cross over? | rubber Jonny | General Discussions & Announcements | 4 | 03-18-2014 05:46 AM |
| Piston for gasgas ec125 2013 | Fasulia | Enduro Engine - 2 stroke | 1 | 12-17-2013 06:53 PM |
| Information please | NewB | GasGas Member Polls | 3 | 10-25-2007 09:36 PM |
| FAQ Information Needed.... | webmaster | General Discussions & Announcements | 0 | 08-02-2006 11:28 AM |
Linear Mode
