|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2 small "cup" washers in linkage?
Ok...first off...thanks for the questions answered in my two earlier posts. Now....I was assembling the linkage/suspension today and ended up with 2 small "cup" shaped washers that I don't remember where they go. The bike has been apart for like 2 months (1st gasgas), and I'm just now getting back to putting it together. Any idea where the go and what direction does the concave/convex point? Thanks. 2011 EC 300
|
#2
|
|||
|
|||
over the bottom shock bearing, they act as a "seal". should be an oring underneath...
|
#3
|
|||
|
|||
Ah ok thanks. So do they go like (I I) or like )I I( against the bottom of the shock? I already installed them like (I I) since it seemed like it kinda pressed against the O-ring to secure it. Hope thats correct.
|
#4
|
|||
|
|||
yep, your right, good to go.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"attn." "new England Boys" | RONALD BRUNDIGE | General Discussions & Announcements | 9 | 11-17-2008 08:19 PM |
"B" piston in an "A" bore? | Kokanee | Enduro Engine - 2 stroke | 6 | 09-04-2006 07:10 PM |
Recommendation: add "Injury/Recover" and "Riding Techniques" sections | MattR | Suggestion Box | 2 | 07-18-2006 09:19 PM |