|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-23-2014, 09:40 AM
|
|||
|
|||
A/B/C marking on cylinder (pic)
Easy question but I never found a clear answer, just want to be clear before I order another piston.
Is the circled spot below where the stamped cylinder size is located? It's marked "A" on mine so I assume so...but ya know...I don't like to assume.  I am planning on buying a Wossner kit this week, am all ears if anyone has other suggestions.
__________________
-Keith '08 EC250 and some other bikes. 
|
|
#2
03-23-2014, 11:16 AM
|
|||
|
|||
|
Yes, that is correct. There was another thread on this subject. That is the correct location and my bike has "A" cylinder like yours.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar
|
|
#5
03-23-2014, 05:14 PM
|
|||
|
|||
|
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar
|
|
#7
03-24-2014, 12:52 AM
|
||||
|
||||
|
The little end bearing is 18x22x21.8
Same CR250 pre 2007, or even a current model YZ250 by the looks (http://www.serco.com.au/bearing-218mm-p-16885.html)
|
|
| Tags |
| bore, cylinder, size |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cylinder marking or piston marking? | d2w | Enduro Engine - 2 stroke | 3 | 02-13-2014 05:50 PM |
| Question about a needle marking | mconnell | Enduro Intake/Carburetion - 2 stroke | 2 | 08-14-2013 02:47 PM |
| Gas tank marking | Binni | General Discussions & Announcements | 6 | 04-13-2011 05:56 PM |
Linear Mode
