|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
A/B/C marking on cylinder (pic)
Easy question but I never found a clear answer, just want to be clear before I order another piston.
Is the circled spot below where the stamped cylinder size is located? It's marked "A" on mine so I assume so...but ya know...I don't like to assume. I am planning on buying a Wossner kit this week, am all ears if anyone has other suggestions.
__________________
-Keith '08 EC250 and some other bikes. |
#2
|
|||
|
|||
Yes, that is correct. There was another thread on this subject. That is the correct location and my bike has "A" cylinder like yours.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#3
|
|||
|
|||
Thank you! I have been reading a lot of posts here, must have missed that one.
__________________
-Keith '08 EC250 and some other bikes. |
#4
|
||||
|
||||
Thats it!
|
#5
|
|||
|
|||
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#6
|
|||
|
|||
Follow up... Is there a crossover for the upper conrod bearing (the caged roller bearing)? Will the CR250 work? Any particular year?
__________________
-Keith '08 EC250 and some other bikes. |
#7
|
||||
|
||||
The little end bearing is 18x22x21.8
Same CR250 pre 2007, or even a current model YZ250 by the looks (http://www.serco.com.au/bearing-218mm-p-16885.html) |
Tags |
bore, cylinder, size |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cylinder marking or piston marking? | d2w | Enduro Engine - 2 stroke | 3 | 02-13-2014 05:50 PM |
Question about a needle marking | mconnell | Enduro Intake/Carburetion - 2 stroke | 2 | 08-14-2013 02:47 PM |
Gas tank marking | Binni | General Discussions & Announcements | 6 | 04-13-2011 05:56 PM |