|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2018 GP300 - Am I up for a New Conrod?
I'm doing an 80 hour piston change on my 2018 GP300 and found that that measuring with feeler gauges that the axial clearance of the big-end bearing is just out of work shop manual spec, measuring at 1.05mm (spec is 0.8 - 1.0mm max).
There is no up & down play in the conrod. The piston and barrel look OK apart from expected piston wear. The manual states 120 hours for replacing the conrod. Would I be pushing it to wait until my next piston change-out at say 150 hours to split the cases & change the conrod? Thanks.
__________________
GG GP300 18 KTM 350EXC 17 GG EC 450, GG EC 250 08, KTM 525 EXC 06, KTM 400 EXC 01, XR400 97, VTR1000 98, VFR750 95, Husaberg FE400 96, RMX250 91, Maico 490 84, IT250J 81, RM250C2 79, Bultaco Alpina 250 77 - All sold |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 gp300 | Colt | New Bikes | 1 | 02-10-2019 04:55 PM |
First Ride 2018 GP300 | Wimpy525 | Ride Reports | 7 | 09-24-2018 10:29 PM |
2018 Gasser GP300 | Colt | GasGas Member Polls | 27 | 07-12-2018 08:10 PM |
2018 gp300 | Colt | Used Bikes | 2 | 06-22-2018 08:14 PM |
2018 GP300 instruments | fred99999au | Enduro Electrical & Wiring | 6 | 05-08-2018 07:27 AM |