|
|
|||||||
| General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-23-2011, 09:53 PM
|
|||
|
|||
plastics...air box
I like the way all the plastics fit on my 2011 300GasGas six days. One thing I do not like are the plastics grab fasteners under the subframe.....what is the purpose????. I will be threading the aluminum or add an insert.
Anyone have ideas?
__________________
www.synergyseals.com 209-938-9726 Being BOLD is BOLD! However, being confident is certain! Ride with confidence again! Made in the USA 
|
|
#2
10-24-2011, 10:06 PM
|
|||
|
|||
|
i just pulled them out and threw them away. the front tabs and the bolt on the side panels holds everything in place just fine.
|
|
#3
10-25-2011, 11:57 AM
|
|||
|
|||
|
Ya. That sounds about right. I will add silicon to the hole so the subframe wont fill up with h2o.
Thanks
__________________
www.synergyseals.com 209-938-9726 Being BOLD is BOLD! However, being confident is certain! Ride with confidence again! Made in the USA
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 99 - 02 KX plastics on GG 05 | brains | Enduro Chassis & Body | 7 | 01-03-2009 04:19 PM |
| gas gas plastics | johns2394 | Enduro Chassis & Body | 1 | 12-09-2008 06:44 AM |
| kx plastics | reeve | Enduro Chassis & Body | 14 | 09-24-2008 07:53 AM |
| Where to get plastics 98 EC - UK | jazzy | Enduro Chassis & Body | 0 | 09-24-2008 04:43 AM |
Linear Mode
