|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
12-13-2013, 05:08 PM
|
|||
|
|||
Will a 500cc Two Stroke Engine fit in an 2011 GasGas Frame
I was considering a new project. I was thinking about looking for a GASGAS rolling chassis. Would a CR500 engine or KX500 engine fit in a 2010/2011 GasGas B Frame? I know the motor mounts would have to be moved, down tube may have to be cut, head on the 500 would have to be turned around for the head mount to clear the fuel tank. Has this ever been done?
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2011 Engine / Frame alignment question | rxmx | Enduro Chassis & Body | 1 | 04-22-2012 11:30 AM |
| 05 engine in a 07 frame | PEB | General Discussions & Announcements | 3 | 10-18-2011 08:55 PM |
| NEW! GasGas EC250 4-stroke w/Yamaha Engine! | GasGasSouthWest | General Discussions & Announcements | 91 | 06-24-2009 05:53 PM |
| An 01 GG 300 engine in an 04 GG 200 or 300 frame? | prentice | Enduro Engine - 2 stroke | 5 | 02-07-2008 12:07 PM |
Threaded Mode