#1
|
|||
|
|||
Longer throttle cable
Local bike mechanic said he did not have the type required for my 2003 ec 200?
Whatever, anyone know where I can go to get one in UK maybe 6 inches longer than standard? I have stacked the front end with higher bars and used all the bar riser plates possible. I have rerouted the cable but it still pulls on tight turns.
__________________
2003 EC200, 2013 Husky TE310, England |
#2
|
||||
|
||||
motion pro # 10 3000 . i think it's plus 2 inches. best of luck.
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
#3
|
|||
|
|||
Venhill do cable kits. The carb end nipple is already fitted, so all you do is cut to length and solder the correct nipple for the throttle end. http://www.venhill.co.uk/Cables_-_Co...sal_Cable_Kits I've used them before and they are good quality. Check that the kit includes all you need, as I had to order a couple of extra small parts.
|
#4
|
|||
|
|||
Cheers guys. Bought a motion pro t3 throttle cable with an extra two inches
__________________
2003 EC200, 2013 Husky TE310, England |
#5
|
||||
|
||||
Just as and add to for future ref.
On earlier twist top carb bikes the motion pro 10-3000 can work but here's my take. Just fitted one and to avoid a tight bend onto the under of tank to carb, I removed the carb end locknut and screwed it fully home. I also added some sealer goob and a cable tie on the rubber fitting as Jake suggested. This makes the bend agreeable. But then there is too much free play so using a maap torch heated the nipple and moved it about 12mm down. Either side, I did throttle end. Then I melted some plumbing solder (not normal 60/40 electrical) into a puddle in a piece of metal, a spot of flux and plunged it in so it flowed all over then removed and held still for quite some time. Dress end on a grinder carefully holding cable and jobs a goodun.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#6
|
||||
|
||||
Good job F5, improvisation is the way to go.
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
03 throttle cable | gassergrant | Enduro Chassis & Body | 0 | 06-10-2014 04:34 PM |
Throttle cable | nato | Enduro Chassis & Body | 9 | 04-11-2014 03:37 AM |
Throttle Cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-14-2009 02:39 PM |
throttle cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-08-2009 06:17 AM |
Throttle cable | dave948 | Enduro Intake/Carburetion - 2 stroke | 7 | 10-10-2008 04:16 PM |