Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 08-18-2019, 02:49 PM
jmkjmk88 jmkjmk88 is offline
Member
 
Join Date: Jul 2016
Posts: 6
Unhappy Weak spark

Hey guys. I?ve been using this site for years to maintain and work on my 2012 300. Took the bike around the block and it just died. Thought it was getting no spark so I tried using a ktm 300 coil new plug n wire to see if that was the problem. Kicked it once and it started, idled rough and cut off after 30 seconds. Put the old coil back on and noticed it is getting spark, just extremely weak. I?ve already cleaned my grounds, checked the stator and its spotless,no rust or corrosion. checked for shorted wires and have gotten no where. I?m at a loss. Has anyone got any insight on what this could be?


Reply With Quote


  #2  
Old 08-18-2019, 04:39 PM
gasgasman's Avatar
gasgasman gasgasman is offline
Super Moderator
 
Join Date: Jul 2006
Location: Pearland Texas
Posts: 4,595
Default

Sounds like a stator issue.
Not producing enough voltage.
Reply With Quote
  #3  
Old 08-18-2019, 04:57 PM
jmkjmk88 jmkjmk88 is offline
Member
 
Join Date: Jul 2016
Posts: 6
Default

Tested the stator with multimeter it?s reading the right output
Reply With Quote
  #4  
Old 08-18-2019, 07:41 PM
(F5)'s Avatar
(F5) (F5) is offline
Gold Level Site Supporter
 
Join Date: Jul 2006
Location: Wellington New Zealand
Posts: 2,071
Default

I'd vote stator too. multimeter wont pick up wires that almost touch but do when they are warm. Mine failed in similar fashion.
__________________
'07 EC300 GG
'14 TXT250 GG
'? 496 CPI Cheetah RZ/RGV hybrid
'22 765 Street Triple RS
'21 XTrainer
'69 Stinger T125 Suzuki
'23 TRS 250RR (it's a Trials thing)
Reply With Quote
  #5  
Old 08-18-2019, 10:30 PM
Gasser Nate's Avatar
Gasser Nate Gasser Nate is offline
Senior Member
 
Join Date: May 2010
Posts: 644
Default

You need a peak voltage adapter to measure its output well enough to say if it is ok. It should be able to pump out at least 100 volts and the source coil and about 5-7 volts for the pick up. It very much sound like a weak stator. Also disconnect the kill switch to rule that out.
__________________
Back on a gassy! 2018 EC300! 🤘
Txt 280 07 to make me feel like a gumby again
Reply With Quote
  #6  
Old 08-19-2019, 02:49 AM
RBrider's Avatar
RBrider RBrider is offline
Gold Level Site Supporter
 
Join Date: Sep 2015
Location: Fla & NC mtns
Posts: 333
Default

Have you replaced the wire end and boot on the spark plug wire?

RB
Reply With Quote
  #7  
Old 08-19-2019, 04:45 AM
Pygmygod Pygmygod is offline
Member
 
Join Date: Jun 2019
Location: Victoria - AUS
Posts: 79
Default

Sometimes you can unscrew the cap, trim off a bit, then screw the cap back on so it's got a nice fresh connection.
Reply With Quote
  #8  
Old 08-20-2019, 02:05 PM
jmkjmk88 jmkjmk88 is offline
Member
 
Join Date: Jul 2016
Posts: 6
Default

Quote:
Originally Posted by Gasser Nate View Post
You need a peak voltage adapter to measure its output well enough to say if it is ok. It should be able to pump out at least 100 volts and the source coil and about 5-7 volts for the pick up. It very much sound like a weak stator. Also disconnect the kill switch to rule that out.
Thankyou for those specs. Killswitch has already been disconnected. Just ordered a peak voltage adapter should be in by tomorrow. I?m pretty bad when it comes to electrical stuff so I really appreciate the help

Last edited by jmkjmk88; 08-20-2019 at 02:38 PM.
Reply With Quote
  #9  
Old 08-20-2019, 04:20 PM
jmkjmk88 jmkjmk88 is offline
Member
 
Join Date: Jul 2016
Posts: 6
Default

Anyone know where I can get a damn stator for this thing? Again it?s a 2012 ec300e headlight tail and signal lights? Not a single shop in New York will touch this thing
Reply With Quote
  #10  
Old 08-20-2019, 06:16 PM
Neil E. Neil E. is online now
Senior Member
 
Join Date: Mar 2007
Location: Gormley, Ontario, Canada
Posts: 1,424
Default

I replied to your other post, but I'll add the answer here too.

http://www.gasgasrider.org/forum/sho...ghlight=stator
__________________
2011 EC250E
Reply With Quote
Reply




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Who said the plastic subframe is weak? rubber Jonny General Discussions & Announcements 3 07-16-2014 07:04 AM
Weak turnover w/ new battery INABIL Enduro Engine 4 stroke (including EFI & Exhaust) 13 11-18-2009 10:13 PM
weak spark tallboy350 Enduro Electrical & Wiring 5 11-24-2008 08:18 PM
weak spark?? Cruiser Enduro Engine - 2 stroke 11 07-01-2007 02:26 PM




All times are GMT -5. The time now is 12:10 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org