|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Frustrating powervalve problem 2018 ec300
Ive just pulled the cover off the right hand side powervalve and removed the lever arm and pulled it off the powervalve. I then removed the small metal plate that connects the arm to the powervalve shaft so i could view the bearing.
Now I am in the process of putting it back together and I am having problems. I can see that this metal plate should spin and make contact with the small screw beside the bearing but it is not going far enough in either a clockwise or counterclockwise direction to make contact with it. It is as though the shaft has moved somehow and it just doesnt want to spin far enough for me to slip the plate back on. Very hard for me to explain it but I hope someone knows what I am talking about. Also, the actuating rod seems to be stuck in the up position and needs a considerable amount of force to move down.. Is this normal. thanks JC |
#2
|
||||
|
||||
It has not spun 180 degrees out has it? Take a look up the exhaust port to see the flap is not hanging too low. Regarding the power valve arm, if you pulled up on it with it disconnected you may have dislodged one of the balls which requires the inner clutch cover to be removed to rectify. Did the power valve just get cleaned?
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#3
|
|||
|
|||
Not sure what went on here. Just went out to look at it after dinner and I can put it on fine. Everything lines up now..
Gassernate thanks again.. JC |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC 300 2018 starter problem | eralha | Enduro Electrical & Wiring | 74 | 10-08-2020 03:41 PM |
GG EC 300 '01 - Rebuild // Powervalve problem | Hugo4x4 | Enduro Engine - 2 stroke | 6 | 06-14-2017 07:10 AM |
Powervalve Drive Shaft EC300 | Leeday | "Wanted to Buy" & "Want To Trade" | 4 | 08-17-2015 03:55 AM |
Another Powervalve problem | J-Meier | Enduro Engine - 2 stroke | 5 | 04-13-2015 12:53 PM |
powervalve/top end problem still! | moff747 | Enduro Engine - 2 stroke | 13 | 02-22-2008 07:21 AM |