![]() |
#1
|
|||
|
|||
![]()
I'm looking at getting a tire stand for doing the tire when using moose's inner tubes.
But they are bloody expensive here, so I thought I might just make one. But I need a couple of photos and some measurements. Anybody willing to sent me or upload some photos and some measurements. Cheers Kim
__________________
08 TXT 300 ![]() 06 Gasgas EC200 03 Gasgas EC300 05 Pampera 250 |
#2
|
||||
|
||||
![]()
This one, by far is the most functional I've ever seen.
The lever has a vertical bar that pushes down on the tire bead while you use the tire tools on the opposite side. Kinda hard to see, but there's a rod that the wheel slides over to hold in place. ![]() http://cgi.ebay.com/ebaymotors/Tire-...ayphotohosting |
#3
|
|||
|
|||
![]()
What is the OD of the top ring ?
K
__________________
08 TXT 300 ![]() 06 Gasgas EC200 03 Gasgas EC300 05 Pampera 250 |
#4
|
|||
|
|||
![]()
Hi Kim,
The O.D. on my zip-ty tire changing stand is 16 3/4 inches. It is similar to the one above without the lever. I use my knees and don't see the need for the lever, I can see that it would be good for breaking the bead on atv tires though... A link to the zip-ty unit is here... http://www.ziptyracing.com/products/...px?id=MTMwOQ== jeff |
#5
|
|||
|
|||
![]()
Well, the darn things are advertised here for nearly NZD600 or about USD400.
At USD90 I would buy one today. K
__________________
08 TXT 300 ![]() 06 Gasgas EC200 03 Gasgas EC300 05 Pampera 250 |
#6
|
||||
|
||||
![]()
Jeff, when mounting Mousse's the lever holds the tire bead down into the rim cavity. It makes it a lot easier. You don't need vice grips to hold the tire down while bull-dogging the tire on.
|
#7
|
|||
|
|||
![]()
I found a used 16" truck rim and welded a axle in the center to keep the wheel centered and stable. A bead breaker could be added from there
Quote:
|
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tire Balls | SpeedyManiac | Enduro Product Reviews | 23 | 04-12-2010 07:05 PM |
Paying it forward: Tire Stand drawing | SpeedyManiac | General Discussions & Announcements | 1 | 06-03-2009 02:30 PM |
Tire changing stand | roostafish | Enduro Product Reviews | 20 | 01-26-2009 07:18 PM |
Best Mud Tire | kim | General Discussions & Announcements | 9 | 04-16-2007 01:10 AM |
Tire Balls | MIKEWA | Enduro Product Reviews | 4 | 11-06-2006 03:39 PM |