Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 01-07-2009, 03:28 PM
darren's Avatar
darren darren is offline
Senior Member
 
Join Date: Jun 2008
Location: Stowmarket. England
Posts: 186
Default Engine difference?

Does any one know what differences there are between the 1998 EC250
And the later models 1999 onwards. Also do any parts crossover??

thanks
Darren


Reply With Quote


  #2  
Old 01-07-2009, 05:18 PM
2 strokes 4 life's Avatar
2 strokes 4 life 2 strokes 4 life is offline
Senior Member
 
Join Date: Apr 2008
Location: Grande Prairie, Alberta, CND
Posts: 678
Default

I think everything but pipes from 07 and on will not work. I think the piston up to 2003 or 2004 will also work.
__________________
2002 Gasgas EC250 (gone not forgotten)
2012 Ktm 300xc
2001 Gasgas EC300
Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!!
Reply With Quote
  #3  
Old 01-07-2009, 07:42 PM
JEEPUSAURUS JEEPUSAURUS is offline
Senior Member
 
Join Date: Oct 2008
Location: Montana
Posts: 108
Default

The '98 cases are a little bit different, the swingarm hole is larger in the '98, and the motor mount holes in the front and bottom are smaller, and i think that the crankcase area is smaller so you cant put a newer cylinder on it(i think) been so long since i had it apart, but i think that is what it was, i know that the cylinder and head are different for sure, side covers are the same, and clutch stuff is too. Trans will swap out with newer stuff.
__________________
99 EC 300
Reply With Quote
  #4  
Old 01-08-2009, 02:25 PM
darren's Avatar
darren darren is offline
Senior Member
 
Join Date: Jun 2008
Location: Stowmarket. England
Posts: 186
Default

Just curious but I noticed the dreaded KTM stamped on the rad scoops does any one know what parts could or would cross over from other bikes??
Reply With Quote
Reply




Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
2k-2 2k-3 ... difference? swazi_matt Enduro Electrical & Wiring 4 10-20-2010 04:52 AM
Difference between the 2010 models? usedtobefast General Discussions & Announcements 9 12-27-2009 07:58 AM
difference between ec250 and ec250 race? Dirt Addict General Discussions & Announcements 2 10-24-2009 02:56 PM
Compression distance difference on pistons Adrian Enduro Engine - 2 stroke 6 05-17-2007 06:50 PM




All times are GMT -5. The time now is 05:00 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org