|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Trailtech Installation and other mods
I have had my 2011 EC 300 with estart for about 10 months. Here are some photos of the Trailtech installation and some other mods.
1. ) This is the trailtech computer with the aluminum mounting bracket, *All of the wires, except the powers leads, are connector specific. So, it is impossible to connect the wrong wires. Very hassle free. If you have a battery, the power leads just connect to the battery terminals. 2.) If you use the aluminum mounting bracket, it will interfere with gps reception. So, a remote antenna is needed. It comes with the bracket. *See photo below. 3.) Here is a photo of the magnetic pickup that slips into the front brake disc, 4.) Here is the speedometer cable that screws directly into your front brake caliper. No drilling required. *See photo below. 5.) This is the coolant temperature sensor. The two clamps are included and a pvc pipe cutter works really well to cleanly cut the radiator hose. If you look to the left you will see a red wire wrapped around the spark plug wire. This provides a signal to the engine hour meter. * Will add photo below later. 6.)This is my sub mounted GPR V4. 7.) This is a Guts Soft Tall Seat that I bought from Mark at Go Fasters. This is the best money that I have ever spent. 8. These are SKF seals that were installed by Drew Smith at WER. This is their condition after six months pounding the Florida sand. GREAT SEALS/GREAT REVALVE! *see photo below.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar Last edited by Moto7man; 09-05-2012 at 09:02 PM. Reason: Problems with links to photos |
#2
|
||||
|
||||
Links no workey.
|
#3
|
|||
|
|||
Links no worky b/c Google is having some kind of issue. I was using photobucket but the uploads were SLOW. What image hosting does everyone else use? How can I make the image appear in the post?
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#4
|
||||
|
||||
Photobucket is super easy.
Place curser over pic you want to post. Wait for drop down menu. Left click on "IMG code" Will say "copied". Go to your post and right click mouse and select paste. That's it. |
#5
|
|||
|
|||
Hey, thanks a lot! I feel like an idiot struggling with these photos. I will give it a try tomorrow!
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#6
|
|||
|
|||
Here is the speedometer cable which screws directly into the brake caliper.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#7
|
||||
|
||||
Good work getting the pics up! Great thread and I'm sure it'll help someone out!
|
#8
|
|||
|
|||
Thanks!
Here is the remote antenna mounted on the rear fender.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#9
|
|||
|
|||
Here is a photo of the SKF seals. It is a little blurry...
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#10
|
|||
|
|||
This is the coolant temperature sensor and engine hour sensor(the red wire wrapped around the spark plug wire). A pvc pipe cutter gives a very clean cut to the radiator hose. The two new hose clamps come with the Trailtech.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear Wheel Bearings - Installation Tip | MattR | Enduro Chassis & Body | 34 | 10-26-2017 02:31 PM |
Front Axle Installation Process | mlyle11 | Enduro Suspension | 2 | 05-20-2012 07:55 PM |
Swingarm installation order? | Trailrider | Enduro Chassis & Body | 2 | 06-18-2009 11:08 AM |
07 EC300 - steahly flywheel weight installation | g dirt | Enduro Engine - 2 stroke | 3 | 06-15-2008 05:42 PM |
Force Radiator Guard Review & installation. | webmaster | General Discussions & Announcements | 0 | 03-03-2008 04:39 PM |