Linkage part

[SS109]

UPDATE: Part Located and purchased!

Looking for this linkage part. I need the upper one which is off of my '05 chassis. The lower is off an '00 and you can see it has a smaller swing arm bolt hole. As you can also see, both parts have the same part #14006 on them.

[nknudsen]

Can you sacrifice the older one and just drill it bigger?

[SS109]

I thought about that but the newer one is over 1/8" wider in that area to accommodate the larger hole. I would be worried about it failing. Of course, it might be just fine. I don't know.

[nknudsen]

Originally Posted by SS109

I thought about that but the newer one is over 1/8" wider in that area to accommodate the larger hole. I would be worried about it failing. Of course, it might be just fine. I don't know.

Now looking at it closer I'd find the larger hole, larger casting one too.

[gumby]

I have a complete linkage set up that I am not going to use. I will try to look at it tomorrow to make sure it is the size you need. But it maybe Sunday before I can.

[gumby]

I looked at my linkage this morning. I have the part you are looking for. I would like to get $50 for the complete linkage setup.

[SS109]

Thanks gumby but I found a replacement.