|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
08-16-2009, 04:10 AM
|
|||
|
|||
Cylinder to Crankcase Gasket order?
I am currently reassembling the top end of my '03 EC200 and i realized that there are THREE different gaskets that all sit on top of each other between the cylinder and the crank case. I have no idea of the order.
See page 113 and 114 of the link below to see what i am referring to (also shows thicknesses) http://www.gasgas.com/manuals/ec_parts_03.pdf Does anyone know the correct order? 
|
|
#2
08-16-2009, 04:40 AM
|
|||
|
|||
The order doesn't matter.
Also, many of us have gone to a single gasket. I use a single 0.3 Some even use a single 0.15, although I've read it doesn't always seal well. I think stock is usually 0.3 + 0.5, not all three, but I guess no harm in using them all. Some other threads: http://www.gasgasrider.org/forum/sho...ht=base+gasket http://www.gasgasrider.org/forum/sho...ht=base+gasket
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crankcase vent blocked | kendunn | Enduro Engine - 2 stroke | 2 | 10-06-2009 12:37 PM |
| Swingarm installation order? | Trailrider | Enduro Chassis & Body | 2 | 06-18-2009 11:08 AM |
| Cylinder gasket leaking. | GavGav | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 05-18-2009 01:25 PM |
| What parts should I order for Marzoc 45mm? | brains | Enduro Suspension | 2 | 05-05-2009 08:34 AM |
| Where order shims | borsiin | Enduro Suspension | 5 | 12-10-2008 04:45 AM |
Linear Mode
