|
All Other Bikes... KTM, Husky, VOR, Husaberg & Hondayamazuki... |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Husky TE 250 Oil plug Dimensions
Does anyone know the dimensions of the oil plug for a TE 250, 2010 ?
Been looking everywhere but i can?t find it, i think it is M12x ??thread?? The owner before me realy messed up the old one, barely got it out ( I would like to kick that Italian bike builders ass for that crappy construction) Just bought a Husky instead of my Gasgas 300, 2006. The Gasgas is a little bit too much for me (n00b) Have not been able to try the husky in the woods yet, but it seems realy nice with electrical start, injection with powerbox and Leovince exhaust :-) |
#2
|
||||
|
||||
GasGas is M12x1,5. This is almost an "standard" dimension for this plugs.
Maybe can be a good start pois to try
__________________
www.endurohp.eng.br Sherco ST300 2015 (Trials) https://www.instagram.com/leocm74/ Brasil! |
#3
|
||||
|
||||
Its a M14 x 1.5 according to the service manual. Do you have the workshop manual? I can send it to you if you need it. The drain bolt is definitely in an awkward place that makes it difficult to remove if you are not patient. In 2013 they relocated the plug, so I guess they listened to the complaining.
I have a 2010 TXC 250 and can give you just about any advice you need. My first piece of advice is to get a torque wrench that measures in inch pounds and use it always. |
#4
|
|||
|
|||
Thanks a lot Phoenix! Yes, i got the manual, but couldn?t find the dimensions :S .
I got a big torque wrench (350 NM ) ^^ , but im about to buy a smaler one i Think. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Footpeg Dimensions | Neil E. | Enduro Chassis & Body | 16 | 10-15-2014 08:56 PM |
2010 300: Handlebar dimensions-who knows ? | husley | Enduro Chassis & Body | 5 | 06-10-2011 11:58 PM |
dimensions needed ltr pv cover | mountain thumper | General Discussions & Announcements | 6 | 05-04-2010 06:29 PM |
Hebo fatbar dimensions? | Leon_gasgas | Enduro Chassis & Body | 5 | 11-25-2008 06:01 PM |
'07 radiator dimensions | GMP | General Discussions & Announcements | 6 | 03-26-2007 09:48 AM |