|
|
|||||||
| Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-31-2008, 04:28 PM
|
|||
|
|||
High speed circut
OK never mine the pull rods ...
I was talking with a very knowledgable suspension guy who had some gncc seat time, about my rear shock. My normal highspeed setting is almost all the way out, something like 3 3/4. He suggested I might try going in the opposite direction as I may have it too soft and the shock is blowing through the stroke and giving me the occasional harsh/kicken rear end. I realize the high speed in the highspeed circut is the speed of the shock shaft not the speed of the bike. I ride tight technical woods 5 to 15 mph. Lots of rot and rock gardens. anyone got any feed back on high speed settings. 06 300, ohlins tr revalve on the back 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low speed high gear stalls in v.slippery conditions | stay_upright | Enduro Engine - 2 stroke | 5 | 04-02-2010 12:48 PM |
| High speed bump performance change? | lvermey | Enduro Engine - 2 stroke | 11 | 06-17-2009 12:06 AM |
| EC250 want more Mid - High Power | gasser250sm | Enduro Engine - 2 stroke | 5 | 12-25-2008 05:55 AM |
| High Compression Head | gasIdaho | Enduro Engine - 2 stroke | 15 | 07-21-2008 11:46 AM |
| Very high idle problem | rupecopp | Enduro Engine - 2 stroke | 5 | 10-22-2007 05:51 AM |
Linear Mode
