|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
12-10-2007, 07:13 AM
|
||||
|
||||
Clutch Drag?
It seems my 03 200ec is having some clutch drag issues. I've been running Shell Rotella 15-40w non synthetic. I ride in Florida it gets very hot and we have very tight sandy trails. I'll work the clutch hard in the tight 1st & 2nd gear trails. I've heard of bleeding out air bubbles in the the clutch line? Has anybody had this happen to them? Or maybe it's time to replace clutch plates. I've done all the adjusting on the lever. When i engage the clutch and put it in gear and try to push the bike it acts like there is not clutch at all. I have since went back to using basic SAE 10w30 oil and still have dragging issues. Any ideas?
Thanks GH
__________________
2003 EC 200 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Yes my Clutch does drag. | (F5) | Enduro Engine - 2 stroke | 42 | 04-09-2019 12:11 AM |
| Does your clutch drag? | stay_upright | Enduro Engine - 2 stroke | 11 | 06-05-2008 03:14 AM |
| 05' EC300 Clutch Drag | gasIdaho | Enduro Engine - 2 stroke | 18 | 09-09-2006 02:53 PM |
Threaded Mode