|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power valve rattle
I know a lot has been posted on this subject but despite numerous searches I can't find an answer to my question.
After doing a top end and de-coking / rebuilding my power valve assembly it has started to rattle quite a bit. Question is, if I leave it to rattle will it cause any damage???? |
#2
|
|||
|
|||
After reading how easy the fix is I decided to have a go.
When I took the PV cover plate on the right hand side I didn't need a feeler gauge to see how big the gap was between the actuating arm and the stop. So after just over an hour and a half I had stripped it down and adjusted out the slop. It has made a vast difference to the running, the bike is so much more responsive off the throttle and seems to get on the pipe a lot quicker. Many thanks for the fix. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power valve did it stick? | mattdenn | Enduro Engine - 2 stroke | 11 | 04-27-2011 04:13 PM |
Power valve noise | rockrider1 | General Discussions & Announcements | 5 | 06-21-2010 02:55 AM |
power valve rattle not chain slap | gasgasandrew | Enduro Engine - 2 stroke | 47 | 06-11-2009 05:24 PM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |
Power Valve Dilemma | gasIdaho | Enduro Engine - 2 stroke | 5 | 08-18-2007 03:06 PM |