|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I check port timing?
Hi, Im about to take the top end apart on my 02 ec300. I want to use the right base gaskets to get the port timing correct. How do I check this? also with correct port timing is there an ideal "squish" ?
|
#2
|
|||
|
|||
.055" per squish. Good luck on the port timing. Some cylinders are quite low. If you end up needing a source for fat gaskets contact this guy.
http://stores.ebay.com/NORTH-TAHOE-M...dZ2QQpZ2QQtZkm |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ec 300 sub port | Gasgasogeros | Enduro Engine - 2 stroke | 13 | 10-24-2010 03:04 PM |
FSR 450 valve check and timing chain | ggg | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 04-22-2010 01:40 AM |
Minor leak from exhaust port help? | jetfish | Enduro Intake/Carburetion - 2 stroke | 5 | 12-24-2009 06:10 AM |
HELP How do I check and alter timing? | wence | Enduro Electrical & Wiring | 3 | 05-09-2009 04:28 PM |
FYI, check BDC piston/lower port clearance. | socalscott | Enduro Engine - 2 stroke | 3 | 11-26-2008 01:43 PM |