|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Clicking/ticking noise
Seems I have this noise Im pretty sure its coming from the flywheel
Can you have a listen to these two vids of it its a bit hard to tell as bike has plug and pipe removed and turning engine over with rear wheel. Piston and barrel look great, have just got all the parts to do the topend so would like to try sort this out at the same time. Is it possible have a cracked magnet in the flywheel and be flicking around as thats what it sounds like. Best heard from about 25 sec on https://www.youtube.com/watch?v=w7Tl...ature=youtu.be https://www.youtube.com/watch?v=93qL...ature=youtu.be
__________________
06 EC250 |
#2
|
|||
|
|||
on my cr I put the stator on just out of line and it clicked a bit.
best is to pull it a part and investigate mate, could be something simple
__________________
03 ec300 honda cr500 94 |
#3
|
||||
|
||||
Found out today that it was the LH main bearing staring to let go but got to it in time.
Is it better to use the roller bearing again or go to the ball bearing style? Also anyone know where I can buy new vforce 3 reeds without buying the whole cage aswell?
__________________
06 EC250 |
#4
|
|||
|
|||
so this has been clicking for about a year now?
Nice to know that Gg parts failure gives so much warning LOL
__________________
2003 txt250 Pro 2013 Ossa 280i |
#5
|
||||
|
||||
Na it didn't get ridden after this vid and was siting in the naughty corner of my shed for a few months until I took out the engine and dropped it of at my mechanic where it sat for even longer. Pity I am not trustworthy to be doing bottom ends
__________________
06 EC250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
clicking noise | rzide | Enduro Engine - 2 stroke | 3 | 02-24-2014 09:11 PM |
noise | bkwdc | Enduro Engine - 2 stroke | 3 | 06-30-2013 11:38 PM |
forks clicking? | baker | General Discussions & Announcements | 0 | 06-29-2008 07:15 PM |
Top end noise ? | Link | Enduro Engine - 2 stroke | 7 | 01-17-2008 03:33 PM |
Bad Noise | roostafish | General Discussions & Announcements | 17 | 01-10-2008 08:30 AM |