GasGas Riders Club Forum  

Go Back   GasGas Riders Club Forum > GasGas Enduro Technical Forums > Enduro Chassis & Body

Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing.


Reply
 
Thread Tools Display Modes
  #1  
Old 01-10-2011, 11:45 AM
jhendr3702's Avatar
jhendr3702 jhendr3702 is offline
Silver Level Site Supporter
 
Join Date: Apr 2008
Location: Amarillo TX
Posts: 1,164
Default short bar risers.....

on my 2001 300, i would like to try to raise the forks in the tripple clamp a line or 2 to experiment... with the stock set up, 7/8 bars, and just the cap on the wp's showing, the top adjuster is almost touching the bars.. I was looking sunday, i dont see any risers under an inch.. Looks to me like you could throw a flat washer or 2 under the clamp and get some room to move them around.. I have seen some stock looking risers on other bikes that look taller than mine, I am pretty short and dont like tall bars at all..
i think somewhere aroun 3/8 would do me fine...Any thoughts ?


__________________
broken down over 50 slow rider..
Reply With Quote


  #2  
Old 01-10-2011, 12:19 PM
GMP's Avatar
GMP GMP is offline
Senior Member
 
Join Date: Jul 2006
Location: Jefferson Twp., NJ
Posts: 7,597
Default

The bikes come with two aluminum spacer washers, about 2-3 mm thick, stacked as risers. I'm guessing yours were removed. A few good flat shim washers will work fine as long as you don't run out of threads on the bolts.
Reply With Quote
  #3  
Old 01-10-2011, 12:29 PM
jhendr3702's Avatar
jhendr3702 jhendr3702 is offline
Silver Level Site Supporter
 
Join Date: Apr 2008
Location: Amarillo TX
Posts: 1,164
Default

thanks glenn... yes i have plenty of threads... was wondering why those were so close...
__________________
broken down over 50 slow rider..
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
RoxSpeed bar risers Trailrider Enduro Chassis & Body 4 08-05-2008 06:02 AM
Boomhauers Short Lived HS Boomhauer Pictures & Videos 0 10-30-2007 08:26 PM
A short Introduction....Finally lukachuki General Discussions & Announcements 3 08-28-2007 07:02 PM
Problem with Scotts tower and bar risers d2w Enduro Chassis & Body 8 07-25-2007 10:30 PM




All times are GMT -5. The time now is 01:21 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org