|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Videos request?
since winter is coming for most parts and most of you will be doing maintenance it would be highly appreciated if you could shoot some videos with your precious action/helmet cam on :
- pv removal and cleaning with the cylinder on - squish and porting measurements - adjusting pv - etc... and in general any oftenly discussed topic around here that needs footage. I'm sure it would be a lot of help not only for the non-english folks. Just a thought... |
#2
|
||||
|
||||
I will be putting a new piston in my EC250 in another 10-20hrs. It appears to have a little blow by at 50hrs now so I'll probably do it in a few more rides. If I can remember I'll roll some footage for you and also demonstrate a squish measurement on the fresh top end.
|
#3
|
||||
|
||||
always a help Jake, much appreciated...
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Request for Shop Manual | GasGasDreamer | Other GasGas Bikes/Quads | 7 | 02-21-2011 07:50 PM |
Special request | roostafish | General Discussions & Announcements | 4 | 03-30-2010 11:08 PM |
Request for a sticky.... | stay_upright | Enduro Intake/Carburetion - 2 stroke | 0 | 07-08-2008 07:10 AM |
Some of my old videos | TeeJay | Pictures & Videos | 6 | 01-18-2007 07:48 PM |