|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
crank rebuild
Oh OK I see, you are dropping the crank off to be rebuilt. That's good ,because a 3 jaw puller would not get that bearing off the crank. You Need a bearing separator style- it has knifed edges,so as you tighten up the nuts. Its forces the puller behind the bearing-get it real good and tight. Then use a press on the WELL supported crank assy.
Its the only way I have ever done main bearings. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
First Top-End Rebuild on a 2007 EC250 | speedy08 | Enduro Engine - 2 stroke | 9 | 06-22-2011 09:16 PM |
EC250 engine rebuild? | robszombie | Enduro Engine - 2 stroke | 3 | 12-07-2009 11:38 AM |