#11
|
|||
|
|||
indeed 27x1 mm LH thread.
|
#12
|
|||
|
|||
Thanks just picked the crank seal out on either side might a well replace both..
|
#13
|
|||
|
|||
Replaced the lh crank seal today but still no joy she just won't start even after a new plug a carb clean slide/needle returns correct.. Any ideas? I seem to be finding fuel coming out the drain bolt at the bottom when I open it.. What would this indicate? The reeds looked ok but could they have failed.. Really havn't got a clue what to do now..
|
#14
|
||||
|
||||
Is the plug wet after kicing it a few times?(drowning)
It has spark and gas, but it sounds like it's getting too much gas.. Airfilter ok? carb clean in all passageways?
__________________
Henrik Schmidt Faster, Faster!! Until the Thrill of Speed, Overcomes the Fear of Death.. Team YamaGas Racing. http://bricksite.com/teamyamagasracing |
#15
|
||||
|
||||
Wonder if the timing has gone, would explain having good spark, and fuel but no starting.
|
#16
|
|||
|
|||
Thanks guys I shall check tommoz and let you know.. It really is puzzling me!
|
#17
|
||||
|
||||
Yeh, maybe flywheel key sheared - wouldn't be the first time....
__________________
Barry 07 EC250 |
#18
|
|||
|
|||
Ive had the fly wheel off to replace the crank seal and the woodruff key from the crank to the fly wheel is fine.. there is a keyway for the outer generator thing that isn't used but that only powers lights etc .. Correct? How often do reeds go? Can they just go slack through wear..?i re built the reed block about 6 months ago with the same old reeds so don't know how old they are.. Also used blue (medium) thread lock on the little philips heads holding the reeds down.. Any more ideas guys? Hopefully we'll stumble across the cause.. Lol
|
#19
|
|||
|
|||
Can anyone tell me why my bike would have a spark and fuel getting through but out keeps flooding..every time I open the crank drain after trying to kick out off fuel comes out
|
#20
|
|||
|
|||
The excess fuel can only come from the carb. Maybe a combination of a faulty choke and a worn needle jet? You would need a failing float valve to get a grossly high level in the bowl and pass significant extra fuel.
__________________
2011 EC250E |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC 300 problem!!!!!!!! | clerky clerk | Enduro Engine - 2 stroke | 31 | 07-06-2011 05:19 PM |
450 Clutch problem | trxpeter | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 09-03-2010 12:38 AM |
And then this became a problem. | dank | Enduro Engine - 2 stroke | 9 | 03-22-2010 07:58 AM |
50 boy problem | Sharpie | Mini Gasser 's Corner | 3 | 09-04-2008 03:58 AM |
I think I have a problem | SpeedyManiac | General Discussions & Announcements | 7 | 11-30-2007 11:26 PM |