|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
09-09-2011, 07:37 AM
|
|||
|
|||
Reusing piston rings
I wanted to try swapping base gaskets to tighten up the squish a little on my '10 300. I have about 40 hours on the bike total and at this point, I don't feel that it needs a top end yet.
Would there be really an issue with swapping out gaskets then using the old piston rings? I would get new gaskets and head o-rings if I did this. GG wants $78 just for rings.. If I absolutely cannot use the old rings, I would just wait until top end time comes around and do it then. Thanks!
__________________
'10 EC300 -- very happy 
Last edited by Bailey28; 09-09-2011 at 08:18 AM. 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piston & rings Questions | biggstr6 | Enduro Engine - 2 stroke | 5 | 08-10-2011 04:36 AM |
| replacing piston and rings? | Rabbitist | Enduro Engine - 2 stroke | 6 | 05-27-2011 03:30 AM |
| piston rings | thenutt | Enduro Engine - 2 stroke | 3 | 06-10-2009 06:16 PM |
| Vertex Piston rings q | FFRDave | Enduro Engine - 2 stroke | 21 | 12-10-2007 04:51 AM |
| Piston and rings EC 300 | brains | Enduro Engine - 2 stroke | 1 | 08-22-2007 12:11 AM |
Linear Mode
